Porsche 911 GT3 Cup MR Gen. II, Technical Manual

Page: 111 / 120

111 Version V2, 08/2020 Porsche 911 GT3 Cup MR Gen.II
Home
ELECTRICS | Traction Control
►
For the 911 GT3 Cup MR Gen.II, a traction control that can be set in 12 levels is optionally available.
The system can be set to 12 levels independently of ABS. Where "0"
means that the system is deactivated. Stage 12 means maximum
control interventions by the traction control.
6.5 Traction Control (TC)
NOTE
The "traction control" function is stored and programmed on the engi-
ne control unit. If the engine control unit is replaced, the "traction con-
trol" function is no longer available.
Programming is done exclusively by Manthey - Racing GmbH. The en-
gine control unit must be sent in for programming.
NOTE
If the control level of the traction control is adjusted via the rotary
selector switch, this change is displayed to the driver in the ICD for
approx. 2 seconds. Control interventions are visually signaled to the
driver via the LEDs on the side of the ICD. The upper LEDs flash purple
for the duration of the intervention.
NOTE
In addition to an appropriately programmed engine control unit, the
correct ICD setup is required for the correct functioning of the traction
control. This can only be ordered through Manthey - Racing GmbH and
is only available to customers with a 911 GT3 Cup MR Gen.II.
NOTE
The following componets are required for the use of the TC:

New dataset for the ECU
 New ICD setup including TC function

Wiring loom with TC rotary switch