Customer Services (858) 578-7887 & (888) GO IN
TEC
IN
TEC
Controls, 12700 Stowe Dr., Suite 110, Poway, CA 92064
Fax (858) 578-4633 & (888) FX IN
TEC
www.inteccontrols.com
Specification subject to change without notice.
Printed in USA 140225
Polygard® is a registered trademark of MSR
SPC3-11XX US
PolyGard
®
Single-Point Controller
User Manual - SPC3-11XX
Page 05
2 Operating Instruction
The complete configuration, parameterization and service are made via keypad user interface in combination with the
display screen. Security is provided via two password levels.
2.1
Description Keypad User Interface
LED orange:
Flashes when alarm one or more alarms are active.
Permanently on, when one of the relays is manually operated.
LED red:
Flashes when alarm two or more alarms are active.
Permanently on, when one of the relays is manually operated.
LED yellow:
Flashes at system or sensor failure or when maintenance needed.
LED green:
Power LED
2.2
Setting / Changing Setups or Set points
Open desired menu window.
Code window opens, if no code level approved.
After inputting the valid code the cursor jumps on the first position segment to be changed.
Push the cursor onto the position segment, which is to be changed.
Change the setup / set point.
Save
the
changed
value.
Finish.
INTEC
SPC3
Alarm 1
Alarm 2
Exit programming mode and saves settings; return to previous level or menu
Enter Main Menus; scrolls through Main Menus and Sub Menus; increase or decrease a value
Navigates through menus on the same level; moves cursor when inputing data
Enter Sub Menus; accepts and stores data; silence horn (if assigned)
