Pioneer PDA-4001, Technical Manual

Page: 36 / 136

36
<Ver. 2.1>
Special installation (Installation on the floor)
3.4.7 Installation on the floor
This display is designed to accommodate floor installation, but certain specific installations may interfere with adequate
ventilation. Always observe the following conditions:
1
Use plate metal that keeps all single holes clear and has dimensions no larger than those given in the following
table.
2
Leave adequate ventilation space between the display and the floor.
3
Use plate metal having sufficient strength, and attach at the four points indicated in the following drawing (four-
point mounting).
4
Recommended ambient operating temperatures are listed in the following table. Operate the display within this
temperature range.
5
The ceiling should closely approximate a perfectly flat plane. Keep deformation pressures upon the display, such
as twisting and bending, at or below 1 mm.
Do not block this area at the top or bottom.
75mm
40mm
Do not block this area at the left or right.
40mm
A
75mm
Floor
694 mm (center indicated) 75mm 75mm
Clearance A to the floor
100 mm or more
50 mm or more
Less than 100 mm
Less than 50 mm
Ambient operating temperatures
0 to 35 °C
0 to 30 °C
Cannot be used.
Remarks