Pioneer PDA-4001, Technical Manual

Page: 24 / 136

24
<Ver. 2.1>
3.4.3 Wall embedding
This display is designed to accommodate embedding in a wall. Note that the allowable range of outside-air temperature
depends on the installation conditions. Please observe the following requirements:
1
If the unit must be embedded in the wall, you must not block the side slots of the unit.
Avoid blocking the ventilating holes in the rear as much as possible.
2
Use a metal mounting fixture that does not block the side slits or the back ventilation holes, and attach at a
minimum of four points. To avoid breaking the PDP panel, limit any twisting or bending stress applied to the
display to 1 mm or less.
3
Do not use cable clamps for this installation method. Cable clamps can interfere with proper ventilation and
result in device failure.
4
Installation conditions and ambient operating temperatures:
(1) If the back of the display will be unobstructed:
Never block the side slots. Avoid
blocking the ventilating holes of the
unit as much as possible.
Side slits
Special installations (Wall embedding)
A
≥
100 mm, B
≤
150 mm
A
≥
100 mm, B
≥
150 mm
A
≤
100 mm, B
≤
80 mm
A
≤
100 mm, B
≥
80 mm
X, Y space upper temperature limits
40 °C
40 °C (Animation), 35 °C (Still)
40 °C
35 °C
C
B A
B
A
B
C
B
X
Y
Intake
MAX 20 mm
Exhaust
Take C to be 30 mm or more.
A A
100 mm 100 mm
Caution