Pinnacle Systems miroVIDEO DV200, User Manual

Page: 17 / 114

User´s Guide
11
5. Remove the slot shield.
Remove the screw and the slot shield for the PCI slot you have selected.
Keep the screw because you will need it later to secure the board once it
is installed.
6. Unpack the board.
Remove the DV200 from its sleeve.
You only need to connect the internal connector to your computer´s power
supply, if you plan to use devices such as video conferencing cameras that
require a 6-pin 1394 cable.
7. Insert the board.
Carefully insert the board into the PCI slot you selected by holding the
board at the top and gently pushing both ends into the slot. Press onto the
upper edge of the board to make sure it is firmly seated in the slot.
8. Fasten the bracket.
Fasten the board´s bracket at the back of the computer using the screw
you saved from the shield.
9. Reassemble the computer, reconnect the cables.
Reassemble the computer and replace the computer cover. Connect all
cables that have been disconnected before the installation.
Now that the hardware installation is complete, you can proceed with the
DV200 driver and software installation (see next chapter).