Commissioning
Operating Manual PMI 6 primo
1004647-EN-02
31
7
Commissioning
Procedure after power-up
There may be a delay of up to 60 seconds between power-up and the device being ready
for operation. The motion control software is preinstalled and it starts automatically. Before
using it for the first time, adapt the IP address via the setup (see
Activating setup [
31]
).
7.1
Safety guidelines
Please note the following safety guidelines during commissioning:
}
When commissioning, you must ensure that the control systems do not present a risk to
persons, plant or machinery. Appropriate protection and precautionary measures must
be put in place.
}
To avoid personal injury and material damage, only qualified, trained personnel should
work on the devices. Qualified technical staff are those who are familiar with the trans-
port, installation, commissioning, maintenance and operation of the device. They will be
familiar with the relevant standards and regulations.
}
Prior to commissioning the machine manufacturer must produce a hazard analysis for
the machine and take appropriate measures to ensure that unexpected movements do
not cause injury to people or damage to equipment.
}
Only specialist staff with extensive knowledge of drive technology and control engineer-
ing should be permitted to program a running drive online.
}
Data stored on data media is not protected from unintended changes by third parties.
Data must be checked for accuracy before it is downloaded to the control system.
}
Prior to installation and commissioning, information in this operating manual, and in par-
ticular the safety guidelines, must be carefully read and considered (see Chapter en-
titled “Safety”). Personal injury and material damage may result if devices are handled
incorrectly.
}
It is essential to comply with the technical details and specifications (type label and doc-
umentation).
7.2
Activating setup
When starting the device, click on
Setup
. The SD card supplied on which the PMI Assistant
is installed must be connected to do this. When the SD card is not connected, the Control
Panel is started.
The PMI Assistant is a graphics software tool and is used for simple installation and config-
uration of common, pre-defined application packages on the PMI.
Further information on the PMI Assistant can be found in the "PMI Assistant Operating
Manual".
