AXL SE PSDI8/3
70 / 84
PHOENIX CONTACT
108928_en_02
6320
+ 034X
FS
flashing
red
E
red on
Symmetry monitoring
has been enabled
and the input pairs
are parameterized as
1-channel
The Smart Element is kept in the
safe state.
Correct the parameterization:
– Disable symmetry monitoring.
– Or parameterize input pairs as 2-
channel.
6320
+ 035X
Restart inhibit has
been parameterized
and the input pairs
are 1-channel and/or
symmetry monitoring
is not activated
Correct the parameterization:
– Deactivate restart inhibit.
– Parameterize input pairs as 2-
channel.
– Activate symmetry monitoring.
6320
+ 03F2
Calculated and
received parameter
data checksums do
not match
•
Check the checksum.
•
Resend the parameter data to
the Smart Element.
6320
+ 03FB
Device type ID is
incorrect or wrong
Smart Element is
being used
•
Check whether the correct
Smart Element is being used.
•
If you are unable to remove the
error, please contact
Phoenix Contact.
8F01
SD
yellow on
Symmetry violation at
indicated input
(
without
start inhibit)
Violation of the parameterized
symmetry has been detected at an
input pair in 2-channel operation.
If start inhibit due to symmetry vio
-
lation is
not
activated:
The input information continues to
be collected and sent to the con
-
troller.
•
Check the sensor.
This diagnostic message can be
acknowledged. Acknowledgment
deletes the message.
SD
yellow on
INx
red on
E
red on
Symmetry violation at
indicated input
(
with
start inhibit)
Violation of the parameterized
symmetry has been detected at an
input pair in 2-channel operation.
If start inhibit due to symmetry vio
-
lation is
activated
:
The inputs are disabled until the
diagnostic message is acknowl
-
edged.
•
Check the sensor.
This diagnostic message can be
acknowledged. Acknowledgment
deletes the message and enables
the inputs.
Error code
(+ AddValue)
[hex]
LED
Error cause
Description/effect
Remedy/acknowledgment