Philips M1165, User'S Reference Manual

Page: 215 / 392

Additional Information
Recording Functions 6-43
Re
c
o
rd
ing
Func
tions
Changing
the
Recorder
Speed
The recording speed can be changed for delayed, realtime, and oxyCRG
recordings made on a bedside recorder. Changes made in the Change
Recording Speed window affect only the
last requested and running
recording.
Note— If more than one bedside recording is running, the Change
Recording Speed window affects only the last requested and running
recording. However, if the last requested recording is stopped, the Change
Recording Speed window then affects the recording that started running
before the stopped one.
Because the recorder must complete the annotation at the beginning of
the strip before the key to access this window appears, there may be a
wait of a few seconds before the speed can be changed. For delayed
recordings, access to the Change Recording Speed window is through the
key. The new speed is not stored.
The speed of alarm recordings cannot be changed; these recordings
always run at 25 mm/sec.
Changing
the
Recorder
You can change the recorder where alarm, delayed, preset, or realtime
non-configured recordings are made.
1. Press .
2. Press .
3. Select the recording type (Delayed & Alarm, Mode, or Procedure).
4. Press
to choose the appropriate recorder.
Continuing
a Timed
Recording
Press on the recorder. The recording runs until you stop it (by
pressing the on the recorder or the softkey on
the display).
Realtime Record
Monitor Setup
Recordng Setup
Change Recorder
CONT
STOP
Stop Recordng