Magnum C3C Spreader Sprayer
Operator Manual
Refer to the cover page for restrictions regarding
reproduction or disclosure of this material.
Page 61
September/08
MAINTENANCE (continued)
u.
Perform Safety Systems Check (refer to Section 4).
7. Scheduled maintenance to be performed QUARTERLY or every 300 hours of operation.
When you perform this maintenance, date the maintenance log, initial the log, and check off
each procedure. Pay particular attention to the following items:
a.
Make copies of the Scheduled Maintenance Log to be used for this machine.
Record completion of each maintenance item. Keep the copy with your Operators
Manual.
b.
Check the machine hour meter. When it flashes LUBE perform the 25-hour
maintenance listed below. The Hour meter will stop flashing automatically whether
maintenance has been done or not.
c.
Perform the maintenance and inspections in the Daily Maintenance Checklist
provided in the Maintenance section. Record all check results in the Daily
Maintenance Checklist.
d.
Change engine oil.
e.
Change clutch oil.
f.
Replace the air filter (refer to engine manual).
g.
Clean the carburetor sediment cup (refer to engine manual).
h.
Check and adjust the spark plug (refer to engine manual).
i.
Check the fuel tank for contamination and residue. Clean the tank and filter if
necessary.
j.
Calibrate the spreader system.
k.
Calibrate the sprayer system.
l.
Check cables. Replace if worn or damaged.
m.
Check and adjust the valve clearance. Unless you are technically qualified, these
checks and adjustments must be done by an authorized Honda service center.
n.
Grease the rear wheel bearings using Mobillux EP 2 grease, or equivalent. Each
wheel has a zerk fitting. If a fitting is missing, replace the fitting.
o.
Grease the articulating rod ends between the spreader and sulky using Mobillux EP
2 grease, or equivalent. Each rod end has a zerk fitting. If a fitting is missing,
replace the fitting.
