Magnum C3C Spreader Sprayer
Operator Manual
Refer to the cover page for restrictions regarding
Page 32
reproduction or disclosure of this material.
Septenber/08
If you have to go up, down, or across steep slopes (15
degrees, or steeper), stop and shift the machine into LOW (L)
gear. Release and lower the handlebar. Walk behind the
machine as you travel the slope.
When you reach level ground, return the handlebar to the
upright position. Make sure the handlebar locks.
Figure 5. Riding the Magnum C3C Spreader Sprayer
6. Loading and unloading the machine from a vehicle.
Do not attempt to start or operate the machine in a confined space; or
where you or someone else could be trapped between the machine any
obstacle; or where you could loose your balance.
a. When loading, center the machine’s tires on the ramps, stop, shift into LOW
gear, drop the handle, and carefully walk the machine up the ramps using the
Brake Lever as needed.
i. Park the machine, turn the Kill Switch to Off, set the Parking Brake,
shift into Reverse,
, close the fuel shutoff valve by turning it
counterclockwise,
and chock the wheels.
ii. Firmly tie down the machine and ramps using appropriate tie-down
straps or all the tie-down devices provided by the Carrying Rack
Manufacturer.
b. When unloading, remove the tie-down devices and lower the ramps, center the
machine’s tires on the ramps, open the fuel valve, start the machine, release
the Parking Brake, shift into REVERSE gear, drop the handle, and carefully
walk the machine down under power using the Brake Lever as needed.
7. Continue new operator training with Section 5 Spreader Calibration, Section 6
Sprayer Calibration, and Section 8 Maintenance..
Keeping the Magnum C3C Spreader Sprayer operating reliably requires attention to
maintenance. This fact MUST be instilled in all operators and mechanics. Use the Daily
Maintenance and Safety Checklist and the periodic maintenance Logs, provided in
Section 8 of this manual, as a maintenance guide. Proper maintenance prevents damage
to your machine, and prevents malfunctions that could occur if the maintenance was not
performed. It is also essential for safe operation of the machine.
