Magnum C3C Spreader Sprayer
Operator Manual
Refer to the cover page for restrictions regarding
reproduction or disclosure of this material.
Page 63
September/08
MAINTENANCE (continued)
i.
Check the fuel tank for contamination and residue. Clean the tank and filter if
necessary. Drain the tank and run empty, or add fuel stabilizer to the gas and run
through system.
j.
Drain and clean the spray tank. Clean in-tank strainer. Flush whole system with
water, then add RV anti-freeze and run through the lines.
k.
Check cables. Replace if worn or damaged.
l.
Check and adjust the valve clearance. Unless you are technically qualified, these
checks and adjustments must be done by an authorized Honda service center.
m.
Grease the rear wheel bearings using Mobillux EP 2 grease, or equivalent. Each
wheel has a zerk fitting. If a fitting is missing, replace the fitting.
n.
Grease the articulating rod ends between the spreader and sulky using Mobillux EP
2 grease, or equivalent. Each rod end has a zerk fitting. If a fitting is missing,
replace the fitting.
o.
Grease each pillow block on the jackshaft located under the hood, using Mobillux EP
2 grease, or equivalent. Each pillow block has a zerk fitting. If a fitting is missing,
replace the fitting.
p.
Grease each zerk fitting (2) on front, underside of transmission/axle using Mobillux
EP2 grease, or equivalent.
q.
Grease each zerk fitting (2) on front wheel hubs using Mobillux EP2 grease, or
equivalent.
r.
Check the belts. Replace if necessary.
s.
Check and adjust the brakes if necessary.
t.
Check and replace the Spinner Platter if necessary.
u.
Perform Safety Systems Check (refer to Section 3).
7.
Flush and clean the spray tank and strainer.
8.
Additional Maintenance.
Replace fluid in tires on repaired or replaced tires. Front drive wheels should weigh NO LESS
THAN 50 pounds, each. Rear tires on sulky should weigh NO LESS THAN 22 pounds, each.
Recreational Vehicle (R.V.) anti-freeze solution is suggested. Refer to page 202? in Operator
Manual.
