Magnum C3C Spreader Sprayer
Operator Manual
Refer to the cover page for restrictions regarding
Page 60
reproduction or disclosure of this material.
Septenber/08
MAINTENANCE (continued)
c.
Perform the maintenance and inspections in the Daily Maintenance Checklist
provided in the Maintenance section. Record all check results in the Daily
Maintenance Checklist.
d.
Change engine oil.
e.
Change clutch oil.
f.
Clean the air filter.
g.
Clean the carburetor sediment cup (refer to engine manual).
h.
Check and adjust the spark plug (refer to engine manual).
i.
Check the fuel tank for contamination and residue. Clean the tank and filter if
necessary.
j.
Calibrate the spreader system.
k.
Calibrate the sprayer system.
l.
Grease the rear wheel bearings using Mobillux EP 2 grease, or equivalent. Each
wheel has a zerk fitting. If a fitting is missing, replace the fitting.
m.
Grease the articulating rod ends between the spreader and sulky using Mobillux EP
2 grease, or equivalent. Each rod end has a zerk fitting. If a fitting is missing,
replace the fitting.
n.
Grease each pillow block on the jackshaft located under the hood, using Mobillux EP
2 grease, or equivalent. Each pillow block has a zerk fitting. If a fitting is missing,
replace the fitting.
o.
Grease each zerk fitting (2) on front, underside of transmission/axle using Mobillux
EP2 grease, or equivalent.
p.
Grease each zerk fitting (2) on front wheel hubs using Mobillux EP2 grease, or
equivalent.
q.
Check the belts. Replace if necessary.
r.
Check and adjust the brakes if necessary.
s.
Flush and clean the spray tank and strainer.
t.
If the spreader or sprayer requires calibration, refer to the procedures in section 3,
CALIBRATION AND ADJUSTMENT.
