Magnum C3C Spreader Sprayer
Operator Manual
Refer to the cover page for restrictions regarding
Page 52
reproduction or disclosure of this material.
Septenber/08
Check the pattern adjustment
hole for the area of the pattern
that is not correct.
Refer to the spreader
adjustment procedure and the
setting numbers recorded at
prior spreader adjustments.
Set the 3
rd
spreader pattern
hole to the proper number and
verify the pattern.
Repeat and modify the
adjustment as necessary.
Inspect the impeller for worn
or clogged blades.
Clean or replace the impeller.
Inspect the impeller for worn
or clogged blades.
Clean or replace the impeller.
Failure Mode
Check
Corrective Action
Check for impeller rotation. If
the impeller is not rotating,
check the following
components:
Check the impeller shaft.
Make sure the impeller shaft
has not separated from the
impeller and that the shaft
assembly block is tight.
If the impeller and impeller
shaft have separated, refer to
the Maintenance and Repair
manual for the repair
procedure.
Spreader does not operate
when the operator lever is
pushed to the OPEN position.
Check the impeller belt and
the drive pulley. Make sure
the belt is correctly adjusted.
If the impeller belt is not
adjusted so that the drive
pulley is driving the belt, refer
to the Maintenance and
Repair manual for the repair
procedure.
