Parker PowerStation XT Series, User Manual

Page: 41 / 99

Display Based Units, Basic Installation Steps
–
VESA Mounting
Perform the following steps to install the XT/IX/PCA PowerStation using a VESA mounting arm or bracket.
Do not use the VESA mounting technique if installing the unit in a UL Hazardous Location environment
(see Warning below).
1.
Verify that all of the PowerStation accessories are present against the items listed in the table at
the beginning of this chapter,
Checking the Shipment .
2.
Use four M4x5 screws (not supplied) to mount the unit to an appropriate swing arm or wall/pole
mounting bracket. The screw length required is dependent on the thickness of the VESA mounting
bracket. The VESA mount spacing on the rear of the PowerStation is either 75mm x 75mm or
100mm x 100mm depending on the display size. For the location of the VESA mounting holes, see:
Physical Dimensions and Panel Cutout in Appendix A.
Display Size VESA Mounting Pattern Dimensions
Headless 100mm x 100mm
7.0 75mm x 75mm
100mm x 100mm
100mm x 100mm
100mm x 100mm
WARNING: Be sure to not exceed the load weight specifications supplied with
the mounting arm or bracket. For example, t PowerStation
weighs 2.6 lbs. (1.18 kg) select an arm that can safely support
this weight. Unit weights can be found in the Appendix,
Physical
Specifications .
WARNING: XT/IX/PCA PowerStation models purchased from Parker with the
following suffixes XTx-xxx-xxx-x 5 , IXx-xxx-xxx-x 5 , PCA-xxx-xxx-
x 5 , intended for use in Class I, Division 2 Hazardous (Classified)
Locations, cannot be used with the VESA mounting arm and the
unit must be installed in a suitable enclosure.