Parker PowerStation XT Series, User Manual

Page: 39 / 99

Touchscreen Units, Basic Installation Steps
– Panel
Mounting
Perform the following steps to install the XT/IX/PCA PowerStation on an enclosure or cabinet panel.
1.
Verify that all of the PowerStation accessories are present against the items listed in the table at
the beginning of this chapter,
Checking the Shipment .
2.
Once a suitable mounting location has been selected, a mounting cutout must be created. Cut a
rectangular hole in the enclosure using the Panel Mounting Cutout dimensions below. (See also
Physical Dimensions and Panel Cutouts in Appendix A) Be sure to follow the cutout dimensions
precisely to ensure that the unit will seal properly against the enclosure surface. Also make sure
that the cutout edges are free of burrs and smooth to allow for proper sealing of the perimeter
gasket. The dimensional tolerance for each cutout is +/- 0.02 (0.5 mm).
Display Size Panel Mounting Cutout Dimensions
7.0
259.5 mm)
3.
Slide the unit into the cutout and attach the supplied mounting clamps, with their screws, to the
perimeter of the unit in the slots provided as shown in the illustration below. Tighten the mounting
clips to
8.7 pound-inch (0.97 Newton-meter)
. Tighten the screws in a crosswise sequence to
ensure a good seal and prevent damage.
WARNING: Do not over tighten the mounting screws! Use a torque wrench to
tighten the clip mounting screws to ensure proper mounting
strength and sealing capability and so that damage to the
PowerStation chassis, mounting clips, or the equipment
enclosure does not occur.
NOTE: The mounting clamps for all units can only support mounting panel thicknesses up to