6. Restraint belt
■
Reastraint belts are designed to secure patients in order to prevent them from falling off.
When transporting a patient or performing the tilting operation, be sure to firmly fasten the
two restraint belts and raise the transfer boards.
●
Do not perform the stretcher operation such as raising the back or knee section base with a
restraint belt attached. The patient's body may be squeezed resuting in injury or the stretcher
may get damaged or deformed.
●
Fasten the restraint belts and make sure there is no slack. If they are not properly fastened,
the patient may fall off or the stretcher may tip over, resulting in an injury.
●
Fasten the restraint belts to designated positions. Otherwise, there is a risk of an unexpected
injury or malfunctions.
●
Do not use the restraint belts if the patient can detach them unexpectedly.The patient may
fall off the stretcher, resulting in injury.
●
Do not fasten cross the restraint belts.There is a risk of an injury.
hoch
Velcro tape
(female)
Velcro tape
Restraint belt
①
Make sure that the restraint belts are fastened.
②
Fasten the restraint belts on the patient and
make sure there is no slack.
[Attaching the restraint belts]
●
Pass the restraint belts into the designated positions as shown in figure and hoch on. Pay
attention to the aspects of the restraint belts, and align the Velcro tape (male) and the Velcro
tape (female) to fasten.
Velcro tape
(male)
27
