ETHERNET
To access Ethernet settings, go to Menu > Network > Ethernet.
Use the settings in the Ethernet menu to configure the GIG-E port. Each camera or device requires a unique IP address. For
camera-to-camera communication via Ethernet, both cameras need to be in the same sub-net (have the same netmask
address) and have the same gateway address.
In the Ethernet menu, you can enable/disable the following:
DHCP: Enables DHCP. If a DHCP-server is available in the communications network, the camera obtains an IP address,
netmask address, and gateway address automatically from the DHCP server. You cannot manually enter anything in the IP
Address, Netmask, and Gateway fields when DHCP is enabled.
Camera to Camera: A change to settings on this camera is sent to other cameras via the network as a SET command (as
UDP packets). The SET command then sets the property on other cameras. If this camera receives a SET command, the
camera does not send the command to other cameras/devices.
External Control: This camera can be controlled via TCP/IP from an external device.
Figure: Ethernet Menu
COPYRIGHT © 2017 PANAVISION INTERNATIONAL, L.P.
FW: V-0.5.35
|
83
PANAVISION MILLENNIUM DXL
Summary of Contents for Millennium DXL
Page 1: ...PANAVISION COM...
