COPYRIGHT © 2017 PANAVISION INTERNATIONAL, L.P.
FW: V-0.5.35
|
112
PANAVISION MILLENNIUM DXL
TIMECODE, GENLOCK, MULTI-CAMERA SETUP
This chapter describes timecode, genlock, and multi-camera operations such as 3D and array setup.
TIMECODE
Timecode is a numeric sequence based on SMPTE 12M that aids in the management and synchronization of footage and
audio. Timecode is embedded in recorded RAW files, QuickTime
®
files (if recording an Apple
®
ProRes codec), and MXF files
(if recording an Avid
®
codec) as metadata and in HANC metadata provided by the HD-SDI monitor output. The camera can
generate timecode on its own or can receive and sync to timecode generated by an external source.
Timecode displays on the side UI panels, SDI overlays and is embedded as metadata. Timecode is represented as an eight (8)
digit sequence (HH:MM:SS:FF), where:
HH: Hours
MM: Minutes
SS: Seconds
FF: Frames
NOTE: Timecode is most accurate and effective when coupled with genlock. For more information, go to
"Genlock" on
page 114
.
SET UP INTERNAL TIMECODE
To set up and adjust timecode generated by the camera, follow the instructions below:
1. Go to Menu > Project Settings > Timecode.
2. Select the desired Display Mode.
3. Set Source to RTC.
4. If applicable, enable LTC Out (Linear Timecode Out).
Figure: Set Up Internal Timecode
Summary of Contents for Millennium DXL
Page 1: ...PANAVISION COM...
