FAN CONTROL MODES
Select a fan control mode.
NOTE: After selecting a new fan setting, run the camera until the core temperature stabilizes, and then calibrate the sensor.
NOTE: Manual mode requires that you actively manage the sensor temperature, because this mode focuses on controlling fan
speed and does not target a narrow sensor temperature range. Use the T/E status indicators as guides for proper temperature
calibration.
NOTE: Maximum speeds are intended as target speeds only; actual fan speeds may be higher at times due to long recording
times or high ambient temperatures.
ADAPTIVE (TARGET TEMPERATURE)
Adaptive is the default mode for the camera.
Select a Target Temperature and the fans self-adjust to maintain the selected temperature. The default Target Temperature
is 39°C. After the camera reaches the Target Temperature, and if the ambient temperature remains constant, Adaptive mode
results in a consistent fan speed and fan noise over time.
Targeting a higher temperature raises the sensor temperature, lengthens the sensor warm-up time, and lowers the fan speed.
Targeting a lower temperature lowers the sensor temperature, shortens the sensor warm-up time, and increases the fan
speed.
NOTE: The intent of Target Temperature is to set the sensor temperature so that you can then create a calibration map for
that temperature.
NOTE: When the camera turns on, the Target Temperature is the temperature of the current calibration map, regardless of
what the Target Temperature was before you turned off the camera. Setting a calibration map also overrides the Target
Temperature. For more information, go to
"Sensor Calibration" on page 93
.
ADAPTIVE PREVIEW QUIET RECORD
Record mode: The camera uses Quiet fan mode. For more information, go to
"Quiet" below
.
Standby mode: The camera uses Adaptive fan mode. For more information, go to
"Adaptive (Target Temperature)" above
.
QUIET
The fans self-adjust to maintain the lowest possible noise level in record and standby mode while still cooling the camera.
MANUAL
Select a speed for the fans in both record and standby modes. The fans self-adjust to maintain the selected speeds. The
default Maximum Record Speed is 75% and the default Maximum Preview Speed is 75%. The range for both Maximum
Record Speed and Maximum Preview Speed is 25–100%.
POST RECORD DELAY
Select the amount of time that it takes for the fan to switch from record to preview mode.
COPYRIGHT © 2017 PANAVISION INTERNATIONAL, L.P.
FW: V-0.5.35
|
86
PANAVISION MILLENNIUM DXL
Summary of Contents for Millennium DXL
Page 1: ...PANAVISION COM...
