–
H.264(4): 512kbps*
* The range of bit rates that can be configured for H.264 bit rates differs depending on the “Transmission
priority” and “Image capture size”.
When “Constant bit rate”, “Frame rate”, “Advanced VBR”, or “Best effort” is selected for
“Transmission priority”
•
160x120 and 160x90: 64kbps - 2048kbps*
•
QVGA, 400x300, VGA, 320x180, and 640x360: 64kbps - 4096kbps*
•
800x600: 128kbps* - 4096kbps*
•
1280x960 and 1280x720: 256kbps* - 8192kbps*
•
1920x1080: 512kbps* - 14336kbps*
•
1920x1080 (60fps) and 1280x720 (60fps): 1024kbps* - 24576kbps*
When “VBR” is selected for “Transmission priority”
•
160x120 and 160x90: 64kbps - 40960kbps*
•
QVGA, 400x300, VGA, 320x180, and 640x360: 64kbps - 40960kbps*
•
800x600: 128kbps* - 40960kbps*
•
1280x960 and 1280x720: 256kbps* - 40960kbps*
•
1920x1080: 512kbps* - 40960kbps*
•
1920x1080 (60fps) and 1280x720 (60fps): 1024kbps* - 40960kbps*
Note
•
The H.264 bit rate is restricted by “Bandwidth control(bit rate)” on the [Network] tab on the “Network”
page (
®
page 126). For this reason, the bit rate may be lower than the value when any value with an
asterisk (*) on the right is selected.
[Image quality]
Select the image quality of H.264 images from the following.
•
When “Transmission priority” is set to “Constant bit rate” or “Best effort”:
Low(Motion priority)/
Normal/ Fine(Image quality priority)
•
VBR:
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low
•
Default:
Normal
Note
•
When “Constant bit rate”, “Best effort”, or “VBR” is selected for “Transmission priority”, this setting is
available.
[Smart Coding mode]
You can turn stream transmission adjustment on and off.
This allows you to reduce the amount of data transmitted when there is little motion in the image.
•
Default:
Off
Note
•
This setting is available when “Transmission priority” is set to “VBR” .
•
When “Smart Coding mode” is set to “On”, the maximum refresh interval becomes 8s.
•
When “Smart Coding mode” is changed from “On” to “Off”, the “Refresh interval” setting returns to the
“Off” value.
•
Turning “Smart Coding mode” to “On” will make refresh interval variable between 1s and 8s. If only
I-frame is used for playback and display, the display interval will change.
[Refresh interval]
Select an interval (I-frame interval; 0.2 - 5 seconds) to refresh the displayed H.264 images.
52
Operating Instructions
8 Configure the settings relating to images and audio [Image/Audio]
