[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to “Navigating through the menu” (
Æ
page 61) for the operation of the menu screen.
[STATUS]
Display the status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The
[STATUS]
screen is displayed.
[SIGNAL]
[NAME]
Displays the name of input signal.
[FREQUENCY]
Displays the scanning frequency of input signal.
[RUNTIME]
*1
[PROJECTOR]
Displays the actual usage time of projector.
[LAMP
(ET-LAV400)]
Displays the model No. of the replacement lamp unit for this projector.
[ECO1]
Displays the luminous lamp runtime in actual time when [LAMP
POWER] is set to [ECO1].
[ECO2]
Displays the luminous lamp runtime in actual time when [LAMP
POWER] is set to [ECO2].
[NORMAL]
Displays the luminous lamp runtime in actual time when [LAMP
POWER] is set to [NORMAL].
[SERIAL NUMBER]
[PROJECTOR]
Displays the serial number of the projector.
[VERSION]
[MAIN]
Displays the main version of the firmware of the projector.
[SUB]
Displays the sub version of the firmware of the projector.
[NETWORK]
Displays the version of the firmware of the built-in wireless module of the projector.
*1
The following conversion is required to calculate the rough estimate for lamp unit replacement.
Formula for lamp unit replacement time (rough estimate)
A
× 1 +
B
× 5/6 +
C
× 5/7
f
A
: The luminous lamp runtime when [LAMP POWER] is set to [NORMAL]
f
B
: The luminous lamp runtime when [LAMP POWER] is set to [ECO1]
f
C
: The luminous lamp runtime when [LAMP POWER] is set to [ECO2]
Note
f
For the network status, refer to the [NETWORK/USB] menu → [NETWORK STATUS]. (
Æ
page 109)
f
The model number of the optional replacement lamp unit is subject to change without prior notice.
[COMPUTER2 SELECT]
Switch the input/output of the <COMPUTER 2 IN/1 OUT> terminal.
1) Press
as
to select [COMPUTER2 SELECT].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[COMPUTER2 IN]
Select when <COMPUTER 2 IN/1 OUT> terminal is used as COMPUTER 2 input.
[COMPUTER1 OUT]
Select when the signal input from the <COMPUTER 1 IN> terminal is output from the
<COMPUTER 2 IN / 1 OUT> terminal.
Note
f
When COMPUTER2 input is selected, [COMPUTER2 SELECT] cannot be set.
f
You cannot switch to COMPUTER 2 input when [COMPUTER2 SELECT] is set to [COMPUTER1 OUT].
f
When set to [COMPUTER1 OUT], the signal input to the <COMPUTER 1 IN> terminal is output from the <COMPUTER 2 IN/1 OUT>
terminal regardless of the selected input.
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press
as
to select [PROJECTOR ID].
ENGLISH
-
87
Chapter 4 Settings - [PROJECTOR SETUP] menu
