Attention
f
Be sure to remove the lens cap before starting projection.
Note
f
If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] (
Æ
page 90) , it may take
approximately ten seconds longer before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.
f
If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], it may take approximately one
minute to enable the network function after connecting the power cord to the outlet.
When the initial setting screen is displayed
When the projector is switched on for the first time after purchase or the [PROJECTOR SETUP] menu →
[INITIALIZE ALL] is executed, the
[INITIAL SETTING]
screen is displayed after the projection starts. Set them in
accordance with circumstances. In other occasions, you can change the settings by menu operations.
When the
[INITIAL SETTING]
screen is displayed, you can return to the previous screen by pressing the
<MENU> button.
Note
f
When the projector is used for the first time, in order to clearly display the menu screen, it may be necessary to adjust the focus lever and the
zoom lever in the projection lens area of the projector (
Æ
page 28). For details, refer to “How to adjust the state of the image” (
Æ
page 53).
Initial setting (display language)
Select the language to show on the screen.
After the initial setting, you can change the display language from the [LANGUAGE] menu.
1) Press
asqw
to select the display language.
ENTER
SELECT
PLEASE SELECT LANGUAGE.
INITIAL SETTING
2) Press the <ENTER> button to proceed to the following initial setting.
Initial setting (projector setup)
If necessary, change the setting of each item.
INITIAL SETTING
PROJECTION METHOD
AUTO
16:10
CENTER
NORMAL
If STANDBY MODE is set to ECO,
you cannot use network functions
when the projector is standing by.
Also, you cannot use some RS-232C
protocol commands.
SCREEN FORMAT
SCREEN POSITION
STANDBY MODE
ENTER
RETURN
SELECT
1) Press
as
to select an item.
Item
Description
[PROJECTION METHOD]
Set [PROJECTION METHOD] depending on the installation mode.
[SCREEN FORMAT]
Set the aspect ratio of the image.
[SCREEN POSITION]
Set the display position of the image.
[STANDBY MODE]
Set the operation mode during standby.
ENGLISH
-
47
Chapter 3 Basic Operations - Switching on/off the projector
