Chapter 2
Getting Started — Attaching/removing the projection lens
46 - ENGLISH
1) Remove the dustproof sponge. (Fig. 1)
2) Remove the top slide cover. (Fig. 2)
f
Slide the top slide cover until the top slide cover attachment line is visible.
Once the top slide cover attachment line is visible, remove by lifting.
3) Confirm that the lens lock lever is positioned at the Unlock side. (Fig. 3)
f
If the lens lock lever is at the Lock side (Fig. 5), pinch the lens lock lever and turn to the Unlock side. (Fig. 3)
4) Align the mark on the projection lens (red) with the protruding mark of the projector, and insert the
projection lens all the way in. (Fig. 4)
5) While holding the projection lens, turn the lock lever fully to the Lock side. (Fig. 5)
f
Make sure to fully turn the lens lock lever.
f
The light source does not light up when the projection lens is not locked.
6) Secure the projection lens with the supplied lens fixing screw.
f
When attaching a projection lens other than the Zoom Lens (Model No.: ET-EMU100) to the projector,
secure the projection lens to the screw hole on the right of the projection lens using a ball point hex driver.
(Fig. 6)
f
When attaching the Zoom Lens (Model No.: ET-EMU100) to the projector, use the ball point hex driver
supplied with the Zoom Lens (Model No.: ET-EMU100) to fix the lens to the screw holes (4 locations)
around the projection lens. (Fig. 7)
The four lens fixing screws supplied with the Zoom Lens (Model No.: ET-EMU100) are the same as the lens
fixing screws supplied with the projector.
7) Attach the top slide cover. (Fig. 2)
f
Align the top slide cover with the top slide cover attachment line, and attach it by sliding.
Attention
f
Store the removed dustproof sponge and the remaining lens fixing screws in a safe place.
f
If the projection lens was replaced, execute the [PROJECTOR SETUP] menu
→
[LENS]
→
[LENS CALIBRATION]. (
x
page 70)
f
When installing the projector to a ceiling or in a high location, install the projector after attaching the projection lens to the projector.