Panasonic M24PWR, Operation Manual

Page: 93 / 235

93
4.7.2.d. LACP Group Status
On the Trunk Configuration Menu, pressing "G" command and specifying
Key that has become LACP group open the LACP Group Status screen, as
shown in Fig. 4-7-10. In this screen, you can confirm the status of LACP
group. (Displaying status is possible only for key of which mode is Active or
Passive.)
Fig. 4-7-10 LACP Group Status
Screen Description
System
Priority System priority is an order of priority in this Switching Hub required for
constructing trunking on the network using LACP. Smaller number has
higher priority. The factory default setting is 1.
System ID System ID is an identifier of this Switching Hub required for constructing
trunking on the network using LACP.
MAC Address of this Switching Hub becomes this System ID, and it is not
possible to change this ID. Combination of System Priority value and
System ID becomes a System ID in LACP.
Key Indicates the group number of trunking.
Aggregator Aggregator is a number of logical interface of trunking. This is the same
number as the one of the port of which Priority value is the highest in
the ports that are constructing trunking.
Attached Port
List This is a number of physical interface (Port) connected to logical
interface (Aggregator). When a trunking group exceeding over 9 ports
was configured, a port having a low Port Priority value gets into backup
mode and is indicated as "Standby."
Standby Port
List When a trunking group exceeding over 9 ports was configured, a port
having a low Port Priority value gets into backup mode. The relevant
port is displayed in this column.
PN23249K/PN23249A Local Management System
Trunk Configuration Menu -> LACP Status
System Priority : 1
System ID : 00:C0:8F:xx:xx:xx
Key : 1
Aggregator Attached Port List Standby Port List
---------- -------------------------------- --------------------------------
2 2
3 3
4 4
5 5
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page [P]revious Page [Q]uit to previous menu
Command>
Enter the character in square brackets to select option