Panasonic M24PWR, Operation Manual

Page: 173 / 235

173
4.7.9.f.1. EAP-Request Port Configuration Menu
On the EAP-Request Configuration screen, pressing "E" opens the
EAP-Request Port Configuration Menu as shown in Fig. 4-7-51. On this
screen, you can configure EAP Request sending for each port in MAC-based
access control mode.
Fig. 4-7-51 EAP-Request Port Configuration
Screen Description
EAP-Request
Interval Displays the EAP-Request sending interval.
Port Displays the port number.
EAP-Request Displays the EAP Request sending status.
Enabled
EAP Request is periodically sent.
Disabled EAP Request is not sent. (Factory default setting)
Available commands are listed below.
N Show the next page.
Press "N" to go to the next page.
P Show the previous page.
Press "P" to go to the previous page.
E Set the EAP Request sending interval.
Press "E." The command prompt changes to "Enter new interval>." Enter a value within
the range specified in the black band at the bottom of the screen.
S Change the EAP request mode.
PN23249K/PN23249A Local Management System
802.1x Access Control Configuration -> EAP-Request Port Configuration
EAP-Request Interval: 5 Sec.
Port EAP-Request
------ ------------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
6 Disabled
7 Disabled
8 Disabled
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page [E]AP-Request Interval
[P]revious Page [S]et EAP-Request Mode
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option