Mounting on a Wooden Wall
The included screws may be used when mounting the main unit on a wooden wall.
1.
Measure the actual space as indicated below to mark the 3 screw positions on the wall.
290 mm
100 mm
200 mm
2.
Install the screws and washers (included) to the wall.
Washer
Drive the screw
to this position.
Note
•
As indicated above, do not tighten the screw fully.
•
The pull-out strength of the installation area must be at least 294 N (30 kgf) per screw.
•
Do not block the operations of the cabinet. Allow space of at least 20 cm above and 10 cm at the
sides of the cabinet.
•
Make sure that screw heads are the same distance from the wall.
•
Install the screw perpendicular to the wall.
3.
Hook the main unit on the screw heads.
112
Installation Manual
4.2.10 Wall Mounting
Summary of Contents for KX-NS500
