Panasonic KX-NS500, Installation Manual

Page: 252 / 338

2.
Enter an extension number.
Note
When no extension number is entered in this step, the process will time out and the IP-PT will be
registered without an extension number.
3.
Press [ENTER]
*1
on the IP-PT.
4.
Press [PAUSE]
*2
or "
EXIT
" on the IP-PT.
*1 For KX-NT551/KX-NT321 users, press [ AUTO DIAL/STORE ].
For KX-NT511 users, press [ CONF/STORE ].
For models other than the above models that do not have the applicable buttons, consult your dealer.
*2 For KX-NT511 users, go off-hook, and then go on-hook.
For KX-UT Series SIP Phones
If networking settings have been completed, when KX-UT series SIP phones are connected to the same
network as the PBX, they will be registered automatically as same as when they are registered in Full Automatic
mode. No registration procedure is required.
Note
•
No more than 64 IP-PTs can register extension numbers at the same time.
•
If an extension number that is input for an IP-PT has already been set to another extension, registration
by this mode will fail.
Note that some extension numbers are pre-configured to other extensions by default. Avoid using such
numbers, or delete them before starting the registration process.
Manual Mode
For IP-PTs or KX-UT Series SIP Phones
After connecting IP-PTs or KX-UT series SIP phones to the PBX over a network, register those IP terminals
to the PBX manually.
Follow the procedure below for registration.
1. a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Place the mouse cursor over the Virtual Slot , and
in the menu that appears, click Select Shelf .
c.
For IP-PTs :
Move the mouse pointer over the V-IPEXT32 card
(Virtual 32-Channel VoIP Extension Card).
For KX-UT series SIP phones :
Move the mouse pointer over the V-UTEXT32 card
(Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property .
To register the IP-PT or KX-UT series SIP phone by entering the MAC address directly:
252 Installation Manual
5.8.1 Registering IP Telephones