Panasonic KX-NS500, Installation Manual

Page: 273 / 338

b.
Click Virtual
®
V-UTEXT32 .
c.
Move the mouse pointer over the V-UTEXT32 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property .
e.
Click the Remote Place tab.
f.
Configure the items shown below.
•
Change the value to Remote (MRG) for Phone Location .
•
Select a protocol (HTTP/HTTPS) for Protocol for Remote SIP-MLT .
Note
When a SIP phone at a remote site uses the internet to communicate with a KX-NS500, use
the HTTPS protocol for security. If the connection is on a VPN and is protected, you may use
the HTTP protocol.
g.
Click OK .
3.
Unplug the AC adaptor of the phone, and then plug it in again to reboot the phone manually. The phone
will download settings automatically.
Note
•
After downloading the setting information for the remote site, the KX-UT series SIP phone will not
connect to the KX-NS500 if it is connected to the LAN at the main site. After some time, the
KX-UT series SIP phone will display "9002: Connection Failed".
•
Depending on the settings of your router, the KX-UT series SIP phone may connect to the PBX. In
this case, proceed to step
4 .
4.
Send the KX-UT series SIP phone to the remote site and connect it to the LAN in the remote site.
Note
The KX-UT series SIP phone is already registered to the KX-NS500 and programmed with the remote
site configuration. No operation is required for the KX-UT series SIP phone in the remote site.
Setting up KX-UT series SIP phones without connecting to the KX-NS500 at the main site, and
then sending them to the remote site
1.
Log in to Web Maintenance Console of the site where the SIP phones will be registered.
2.
Click Utility
®
File
®
File Transfer PBX to PC .
3.
Select the config file according to the protocol used and then download it to your PC.
•
If HTTPS is used:
–
UT_MRG_HTTPS_xxyyyy.cfg
For more details about downloading files from a PBX to a PC, refer to "7.2.2 Utility—File—File Transfer
PBX to PC" in the PC Programming Manual.
Note
xx: Site ID (2 digits)
yyyy: Site name
*1
(Up to 32 characters
*2
)
*1
Spaces as well as the following characters in site names will be replaced with underscores.
/, :, *, ?, ", <, >, | (vertical bar), &, +
*2 In some cases, the full site name may not be included in the file name even if it is less than 32 characters.
4.
Download the config file to the KX-UT series SIP phone via the Web user interface of the KX-UT series
SIP phone. For details, refer to "When the SIP Phones are in a different LAN (Remote site installation)" in
"5.7.1 Assigning IP Addressing Information".
5.
Connect the KX-UT series SIP phone to the LAN in the remote site.
6.
Register the KX-UT series SIP phone to the KX-NS500 as a remote extension.
a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Click Virtual
®
V-UTEXT32 .
Installation Manual 273
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway