Panasonic KX-NS1000, Manual

Page: 444 / 542

Tenant No. Operator ARS Mode Music Source System Speed Dialling
: : : : :
*1 Follows the system assignment of a PBX operator.
®
10.2 PBX Configuration—[2-2] System—Operator & BGM— PBX Operator—Day, Lunch, Break, Night
*2 Follows the system assignment of the ARS mode.
®
Section 16 PBX Configuration—[8] ARS
*3
Follows the system assignment of the music source for the Music on Hold.
®
10.2 PBX Configuration—[2-2] System—Operator & BGM— BGM and Music on Hold—Music on Hold
*4
Follows the system assignment for System Speed Dialling.
®
14.1 PBX Configuration—[6-1] Feature—System Speed Dial
Conditions
•
One-look Networking (
®
4.2 One-look Networking)
For features whose operation depends on Time Service (
®
5.1.4 Time Service), system programming
specifies which PBX’s clock is used to determine the time mode.
®
14.6 PBX Configuration—[6-6] Feature—Tenant— Time Service Mode
•
ARS Assignment
When "
On for Local Access Operation
" or "
On for Any CO Access Operation
" is assigned
as the ARS Mode for a tenant, only a subset of the ARS Leading Number Table is applied to that tenant’s
outgoing calls. Tenants 1 to 20 are assigned a range of 50 of the entries in the Leading Number Table as
follows:
–
Tenant 1: Entries 1 to 50
–
Tenant 2: Entries 51 to 100
–
Tenant 3: Entries 101 to 150
:
–
Tenant 20: Entries 951 to 1000
If "
Same as System Setting
" is selected, then all 1000 entries in the table will be applied to that
tenant’s outgoing calls. All 1000 entries in the table are applied to tenants 21 to 32/128 when ARS is
enabled, regardless of the tenant’s ARS Mode.
By dividing tenants, specific ARS settings can be applied to specific tenants according to the requirements
of each tenant.
The following example illustrates how the ARS Leading Number Table is applied to tenants:
Tenant No. ARS Mode Applied ARS Entries
1 On for Local Access Operation Entries 1 to 50
2 Off Not applied
3 Same as System Setting (System Setting:
On) Entries 1 to 1000
4 On for Local Access Operation Entries 151 to 200
5 Off Not applied
•
Tenant-to-Tenant Call Block
The following features can be restricted based on the COS for each extension (not based on the tenant)
by the Internal Call Block feature (
®
2.1.2.2 Internal Call Block):
–
Calling extensions or doorphone(s) in the restricted tenant(s)
–
Picking up calls ringing in the restricted tenant(s)
–
Retrieving a call held within the restricted tenant(s)
444 Feature Guide
5.1.3 Tenant Service