Panasonic HL-G1-A-C5 Series, User Manual

Page: 87 / 158

3-3-11
Measurement Control with External Input

Timing
This function makes it possible to hold the measurement value at the
desired timing.
The measurement value will be kept on hold with external input timing (TM). The
judgment output is kept on hold as well simultaneously.
Timing settings can be executed with communications command but not with the
operation of the panel.
For the operation of the system in this mode, refer to "2-4 Timing Chart".
"Judgment Output" will be kept on hold by setting the timing input to "ON" at
the desired timing. This enables loading of the judgment result at a later time.
•
The timing input status cannot be stored by executing “Save”. Timing input will
be OFF right after the system is turned ON or a memory change is made.
•
If the timing mode is set to "One Shot," the internal memory will be cleared (set
to timing OFF) after one-shot processing is executed when timing ON is executed
with a communications command.
•
If the timing mode is set to "Hold," the external input status will be reflected on
the memory.

Zero Set
This function makes it possible to set the measurement value to zero at the
desired timing.
The measurement value can be set to zero at the desired timing by using external
multi input (MI).
Input a specified pulse width as multi input.
Zero set settings can be executed with communications commands and the
operation of the panel.
For the operation of the system in this mode, refer to
"2-4 Timing Chart".
•
An offset value will be set by executing “Zero Set” after setting the offset value.
•
The sensor head does not save setting changes made over the multi-input line.
Save the settings over the multi-input line, through the panel, with the
communications command, or with the operation of the console if the settings
need to be maintained after the system is turned OFF.
Ramco National 800-280-6933 | nsales@ramcoi.com www.panasonicsensors.com