Panasonic HL-G1-A-C5 Series, User Manual

Page: 43 / 158

Class Function Details
Initial value
Memory
change*
Ref.
page
Ou
tpu
t S
etti
ng
s
Judgment Output
Selection
Sets the operation of the output block.
Default: 2-state

3-23
Displace
ment
Judgment
Threshold a
Sets threshold a
and threshold b.
Default: +(detection range)
Default: -(detection range)

3-25
Threshold b
Hysteresis
Sets the hysteresis.
Default: +(0.2% of setting range)

Judgment Output OFF
Delay
Delays the timing of judgment output switched OFF
from ON.
Default: OFF

3-27
Measurement Value
Display on Panel
Turns OFF the rightmost digits on the digital display.
Default: SET 1

3-29
An
alo
g S
et
ting
s
Analog Output
Selection
Selects the desired output type from current output and
voltage output.
Default: Current output

3-30
Analog
Scaling
Meas A
Performs scaling
the analog current
output and the
analog voltage
output to any
desired value.
Default: Negative measurement range

3-31
Meas B
Default: Positive measurement range

Current a
Default: +4.000 mA

Current b
Default: +20.000 mA

Voltage a
Default: 0.000 V

Voltage b
Default: 10.000 V

Al
arm
S
etti
ng
s Analog Output at Alarm
Sets the analog output status at alarm operation.
Default: Holds previous value

3-33
Digital Output at Alarm
Sets the digital output status at alarm operation.
Default: Holds previous value

3-34
Alarm Delay Times
Holds the previous normal value up to the setting
number of times if an alarm is issued.
Default: 8 times

3-35
CO
M
S
et
tings
Terminating Resistor
Selection
Selects the terminating resistor for the sensor head
connecting to the host device over RS-422/485.
Default: R3

3-36
Sensor no.
Sets the number of each sensor head multi connected
to an RS-485 device.
Default: 01

3-37
Baud rate
Sets the communication speed. Default: 38400 bps

3-38
Connection Mode
Selects the performance settings for measurement data
output to the host device.
Default: RS-485 Multiple

3-39
Sending Delay Time
Set the sensor's delay time in response to each
command transmitted from the host device.
Default: 0ms

3-40
Sys
tem
S
et
tin
gs
Timing Mode
Sets the timing input mode. Default: Hold

3-41
Laser Control
Switches laser emission/stop. Default: Emission

3-42
Eco Mode
Turns OFF the LED indicators on the control panel for
energy saving while the system is in RUN mode.
Default: Eco OFF

3-43
View Version
Displays the program version of the sensor. - 3-44
Initialization
Initializes the memory settings currently in use.

3-45
Save
Saves all memory settings.

3-46
Timing
Holds the measurement value. Default: OFF - 3-47
Ramco National 800-280-6933 | nsales@ramcoi.com www.panasonicsensors.com