Panasonic Foma p705im, Instruction Manual

Page: 46 / 554

44
Be
fo
re Us
in
g the Hand
set
1
Press and hold
h
for at least one
second.
After the Wake-up display (see page 102) is displayed,
the Stand-by display appears.
≥
If you have stored many Phonebook entries or mail
messages, it may take a while for the display to
appear.
≥
If Set Time is set, the current date and time are
shown.
≥
When “ ” is displayed, the FOMA phone is out of
the service area or in the place where the radio
waves do not reach. Move to a location where “
”
disappears.
≥
If “starting system wait a minute” is displayed when
you turn on the power, wait for a while and then
proceed.
Enter the four- to eight-digit Terminal Security Code after turning on the power.
When you enter the correct Terminal Security Code, the Stand-by display appears. If
you enter the incorrect Terminal Security Code five times in succession, the power
turns off. (However, you can turn on the power again.)
Enter the four- to eight-digit PIN1 code after you turn on the power. When you enter
the correct PIN1 code, the Stand-by display appears. See page 121 for PIN1 code.
Enter the four- to eight-digit PIN2 code after you turn on the power. When you enter
the correct PIN2 code, the Stand-by display appears. If you press
r
or
h
without entering the correct PIN2 code, “Auto reset setting” is set to “OFF” and the
Stand-by display appears. See page 121 for PIN2 code.
Power ON/OFF
Turning Power On/Off
Turn Power On
< >
Stand-by display
When your UIM is replaced (except during Omakase Lock)
When “PIN1 code entry set” of “UIM setting” is set to “ON”
When “Auto reset setting” of “Notice call cost” is set to
“ON” (except during Omakase Lock)
1
Press and hold
h
for at least two seconds.
The exit display appears and the power turns off.
≥
You cannot turn on the power immediately after turning off the power. Wait a
few seconds.
1
m
1
設定 (Settings)
1
ディスプレイ (Display)
1
バイリンガル (Select language)
1
Japanese ( 日本語 ) or English ( 英語 )
≥
The following functions are different between Japanese display and English display:
Information
≥
Each entry display appears in the order of “PIN1 code” → “Terminal Security
Code” → “PIN2 code”.
Turn Power Off
+ m - 1 - 5
Select Language
Switching to English
< >
Functions Japanese English
Info Notice Setting
電子音 (Electrical tone)
ボイス
(Voice)
OFF
ON
Not available
OFF
“Clock” of Display Setting
→ “Day of week”
Available Not available
使いかたナビ
(Guide)
Available Not available
Voice Guidance Available Not available
Information
≥
When you insert the UIM, the “ バイリンガル (Select language)” setting is stored on
the UIM.