Panasonic DP-1510P, Service Manual

Page: 374 / 486

374
APR 2002
Edition 2.0
DP-1510P/1810P
/1810F/2010E
(25) If there is no space, adjust the Platen Glass
position by following the procedure below:
a. Open the ADF Unit.
b. Remove 3 Silver Screws.
c. Remove the Left Platen Cover.
d. Loosen 2 Screws.
e. Shift the Scanning Glass Guide to the left
and tighten the 2 Screws.
f. Re-install the Left Platen Cover and secure
it with 3 Silver Screws.
(26) Install the 2 Hinge Stoppers.
(27) Secure the 2 Hinge Stoppers with 4 Screws
(XTB3+8J).
(28) Install the 2 Hinge Covers.
Note:
When installing the Hinge Covers, make sure that
a Hinge Film is placed inside of each Hinge Cover.
(29) Peel off the 6 adhesive protectors from the
Scanning Pad.
(30) Place the Scanning Pad on the glass aligning it
on the upper left corner, keeping 1mm space as
illustrated.
(31) Close the Automatic Document Feeder.
Note:
Re-open the ADF Unit and push the Scanning Pad
gently to paste it properly.
(32) Perform Service Mode F6 (No. 90, 91, 93 and
94) to adjust the ADF Scanning Position.
(b)
(c)
(d)
(d)
(e)
(27)
(26)
(28)
(31)
(30)
(29)
1mm