Panasonic DLP PT-FRZ50, Operating Instructions (Functional Manual)

Page: 42 / 189

Chapter 3 Basic Operations — Switching on/off the projector
42 - ENGLISH
Initial setting (installation setting)
Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.
Refer to “Installation mode” (
x
page 30) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu
→
[PROJECTION METHOD].
1) Press
qw
to switch the setting.
2/6
ENTER
SET
CHANGE
Change the projection method
(FRONT/REAR, FLOOR/CEILING)
if the screen display is upside down
or inverted.
PROJECTION METHOD
INITIAL SETTING
FRONT/REAR
FLOOR/CEILING
MENU SELECT
FRONT
AUTO
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this item to [ECO].
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu
→
[ECO
MANAGEMENT]
→
[STANDBY MODE].
1) Press
qw
to switch the setting.
3/6
When set to ECO,
network functions and some RS-232C commands
are not available during standby.
INITIAL SETTING
SET
CHANGE
STANDBY MODE NORMAL
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f
The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. When the [PROJECTOR
SETUP] menu
→
[INITIALIZE]
→
[ALL USER DATA] is executed, the [STANDBY MODE] setting before executing is displayed.
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image.
After completed the initial setting, you can change the settings of each item from the [DISPLAY OPTION] menu
→
[SCREEN SETTING].
1) Press
qw
to switch the setting.
f
Proceed to Step 4) when [16:10] is selected.