Panasonic DLP PT-FRZ50, Operating Instructions (Functional Manual)

Page: 26 / 189

Chapter 1 Preparation — About your projector
26 - ENGLISH
19 8 11
Projection direction
Bottom Top
1 Remote control signal receiver (front)
2 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3 Light source indicator <LIGHT>
Indicates the status of the light source.
4 Temperature indicator <TEMP>
Indicates the internal temperature status.
5 Projection lens
6 Lens shift lever
Adjusts the projection position.
7 Adjustable feet
Adjusts the projection angle.
8 Intake vent
9 Exhaust vent
10 Remote control signal receiver (rear)
11 Luminance sensor
This is a sensor to detect the luminance of the installed
environment.
When the [PICTURE] menu
→
[DAYLIGHT VIEW] is set to
[AUTO], the luminance of the installed environment is detected by
the luminance sensor to automatically perform appropriate picture
quality correction.
12 Focus ring
Adjusts the focus.
13 Zoom ring
Adjusts the zoom.
14 Control panel (
x
page 26)
15 Connecting terminals (
x
page 27)
16 Security slot
This security slot is compatible with the Kensington security
cables.
17 <MAIN POWER> switch
Turns on/off the main power.
18 <AC IN> terminal
Connect the supplied power cord.
19 Burglar hook port
Attaches a burglar prevention cable, etc.
Attention
f
Do not block the intake and exhaust vents of the projector.
r
Control panel
3 1
2
1 Power <
v
/
b
> button
Sets the projector to the state where the projector is turned
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
Sets the projector to projection mode when the power is switched
off (standby mode).
2 <MENU> button/<RETURN> button/<ENTER> button/
asqw
buttons
Used to navigate through the menu screen.
Also used to enter a password in the [SECURITY] menu or enter
characters.
3 <INPUT SELECT> button
Switches the input signal to project. (
x
page 49)