Panasonic DLP PT-FRZ50, Operating Instructions (Functional Manual)

Page: 30 / 189

Chapter 2 Getting Started — Setting up
30 - ENGLISH
Setting up
Usable outlet
This projector supports AC 110 V (for Taiwan) or AC 100 V to AC 240 V (for other countries or regions) as the
power supply. A grounded outlet supporting 15 A is required with either voltage.
The shape of the usable outlet differs depending on the power supply. Following illustrations are examples.
2P/3W 15 A 250 V
2P/3W 15 A 250 V
2P/3W 15 A 250V
2P/3W 15 A 125 V
Attention
f
Use the supplied power cord and ground at the outlet.
f
Use the power cord matching the used power supply voltage and outlet shape.
Note
f
The supplied power cords vary depending on the country or region where you purchased the product.
Installation mode
The installation modes of the projector are as follows. Set [FRONT/REAR]/[FLOOR/CEILING] in the [PROJECTOR
SETUP] menu → [PROJECTION METHOD] (
x
page 94) depending on the installation mode.
Setting on a desk/floor and projecting forward Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Menu item Setting value Menu item Setting value
[FRONT/REAR] [FRONT] [FRONT/REAR] [REAR]
[FLOOR/CEILING] [AUTO] or [FLOOR] [FLOOR/CEILING] [AUTO] or [FLOOR]
Mounting on the ceiling and projecting forward Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item Setting value Menu item Setting value
[FRONT/REAR] [FRONT] [FRONT/REAR] [REAR]
[FLOOR/CEILING]
[AUTO] or [CEILING]
[FLOOR/CEILING]
[AUTO] or [CEILING]