b.
Under [Multicast (IPv4)], check [Use] to enable multicasting for IPv4. If used, the following settings are
also necessary.
i.
Enter the IP address of the multicast.
ii.
Enter the first port number to be used for MPEG-4 streaming (video only; audio is streamed on the
audio port specified on this page). This port number must be an even number.
iii.
Enter the first port number to be used for H.264 streaming. This port number must be an even
number.
iv.
Enter the port number to be used for audio streaming. This port number must be an even number.
c.
Under [Multicast (IPv6)], check [Use] to enable multicasting for IPv6. If used, the following settings are
also necessary.
i.
Enter the IP address of the multicast. This address must be an IPv6 address.
ii.
Enter the first port number to be used for MPEG-4 streaming (video only; audio is streamed on the
audio port specified on this page). This port number must be an even number.
iii.
Enter the first port number to be used for H.264 streaming. This port number must be an even
number.
iv.
Enter the port number to be used for audio streaming. This port number must be an even number.
5.
Click [Save].
•
When any of the following settings are changed, the camera must be restarted before the new setting
takes effect. All images buffered in the internal memory are deleted when the camera is restarted.
–
[Streaming Format]
–
[Max. No. of HTTP Sessions]
–
[Max. No. of HTTPS Sessions]
Note
•
Streaming H.264 or MPEG-4 video by multicast may increase the traffic on your network. Consult your
network administrator before enabling this feature.
•
If video streaming settings are saved while users are viewing H.264 or MPEG-4 images, the video
stream may stop. Users can start the stream again by clicking the refresh button in their web browsers.
•
To increase image quality when streaming H.264 or MPEG-4 images, decrease the frame rate.
•
To increase the frame rate, increase the setting for minimum bit rate.
•
If H.264 or MPEG-4 images are unstable, reduce the setting for maximum bit rate and set the streaming
method to HTTP.
•
If the network has little bandwidth or if H.264 or MPEG-4 images break up, set the streaming method
to HTTP.
•
In order to stream H.264 or MPEG-4 images using unicast over the Internet, the port numbers used
by RTP must be configured for the port forwarding feature of your router. If images cannot be displayed
or if images break up when [Unicast] is selected as the streaming method, select [HTTP].
•
Screen content varies by model number.
•
BL-C230 only:
When in wireless mode, Multicast may not work properly because the IEEE 802.11
standard limits the bandwidth. Select [Unicast] or [HTTP] as the streaming method.
Operating Instructions
149
5.8 Changing Video Streaming Settings
Summary of Contents for BL-C210 Series
Page 124: ...6 After the wizard is displayed click Next 124 Operating Instructions 5 2 HTTPS Settings ...
Page 126: ...9 Click Next 126 Operating Instructions 5 2 HTTPS Settings ...
Page 127: ...10 Click Finish Operating Instructions 127 5 2 HTTPS Settings ...
Page 131: ...6 Click Finish 7 Click Yes Operating Instructions 131 5 2 HTTPS Settings ...
