Panasonic AJ-PX5100G, Operating Instructions Manual

Page: 160 / 263

– 160 –
Chapter 6 Menu Operations — Menu list
[HIGH SETTING]
Item Description of settings
[[S] MASTER GAIN] Selects the master gain.
[ − 6dB], [ − 3dB], [0dB], [3dB], [6dB], [9dB], [12dB], [15dB], [18dB], [21dB], [24dB], [27dB], [30dB]
f Factory setting: [12dB]
[H.DTL LEVEL] Sets the horizontal detail correction level.
[0]…[63]
f Factory setting: [6]
[V.DTL LEVEL] Sets the vertical detail correction level.
[0]…[31]
f Factory setting: [10]
[DTL CORING] Sets the detail noise removal level.
[0]…[60]
f Factory setting: [12]
[H.DTL FREQ.] Selects the horizontal detail frequency.
[0]…[31]
f Factory setting: [18]
[LEVEL DEPEND.] Sets the [LEVEL DEPEND.].
Compresses the details of dark areas when Y detail is emphasized.
Details of bright areas are also compressed if the value is large.
[0]…[5]
f Factory setting: [1]
[MASTER GAMMA] Sets the master gamma in 0.01 steps.
[0.30]…[0.75]
f Factory setting: [0.55]
[BLACK GAMMA] Sets the gamma curves of dark areas.
[ − 8]…[ − 1]: Compresses the dark areas.
[OFF]: Standard state
[1]…[8]: Expands the dark areas.
f Factory setting: [OFF]
[B. GAMMA RANGE] Sets the maximum level of compression/expansion.
[1]: About 20%
[2]: About 30%
[3]: About 40%
f Factory setting: [1]
[[S] MATRIX TABLE] Selects the color collection table for the linear matrix.
[A], [B], [OFF]
f Factory setting: [A]
[[S] COLOR CORRECT] Switches the 15-axis independent color correction on/off.
[ON], [OFF]
f Factory setting: [ON]
@ @
NOTE
t When saving or reading setup files from an SD memory card, you can save items with an [S] and items without an [S] separately. Items with an [S] in
front of the item name are the targets for [PAINT([S]SELECT)] in the main menu
→ [FILE] → [SETUP DATA SELECT]. Items without an [S] are targets
for [PAINT(LEVEL)].
t [ − 6dB] in [[S] MASTER GAIN] cannot be selected when [NORMAL] is set in main menu → [PAINT] → [[S] CAMERA SETTING] → [SHOOTING
MODE].
[ADDITIONAL DTL]
Item Description of settings
[KNEE APE LVL] Changes the detail level of high-brightness areas.
[OFF], [1]…[5]
f Factory setting: [2]
[DTL GAIN( + )] Changes the level of + (upper) direction of detail.
[ − 31]…[31]
f Factory setting: [0]
[DTL GAIN( − )] Changes the level of − (lower) direction of detail.
[ − 31]…[31]
f Factory setting: [0]
[DTL CLIP] Sets the level at which detail signals will be clipped.
[0]…[63]
f Factory setting: [0]
[DTL SOURCE] Sets the ratio of RGB signal components that will create the detail.
[(R + G)/2], [(G + B)/2], [(2G + R + B)/4], [(3G + R)/4], [R], [G]
f Factory setting: [(R + G)/2]
[MASTER DTL] Changes the master detail level.
[
−
31]…[31]
f Factory setting: [0]