W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
64
:HOGLQJ&RQGLWLRQV
This section explains basic welding conditions with useful functions.
%DVLFZHOGLQJFRQGLWLRQV
This section explains the basic welding conditions. To carry out the welding operation, the followings should be
considered:
•
Plate thickness and materials of welding material
•
Type and flow rate of shield gas
•
Wire type and wire diameter, and welding method (type of welding)
•
Welding current and welding voltage
8VHIXOIXQFWLRQV
This section explains the useful functions for the welding power source.
•
Registration of welding conditions (
6.5
-
Memory Function of Welding Conditions)
Using the memory function of the welding condition enables to register the welding current/voltage, shield gas type,
and wire type/wire diameter currently set, and reads them out for use.
•
Synergic adjustment of voltage (
6.2
-
Function on Operation Panel)
Using the VOLT. ADJUST menu enables to automatically set the welding voltage according to the welding current.
Fine adjustment of the welding voltage automatically set is also available.
•
Penetration control (
6.6.8
-
Penetration control adjustment)
Using the penetration control function can automatically adjust the wire feed speed so that the constant welding
current is always kept even with the wire feeding length changes. (Available only for MILD STEEL SOLID, MILD
STEEL CORED, STAINLESS STEEL SOLID or STAINLESS STEEL CORED)
•
Welding current adjustment by torch switch (
6.7
-
Setting Internal Functions)
Using the internal function (F48) enables to increase or decrease the welding current set by the torch switch operation.
(Available only with the CRATER-FILL ON is selected and with welding condition)
3UHSDULQJ:HOGLQJ&RQGLWLRQV
This section explains the setting process of basic welding conditions.
Check welding material suitable for the welding condition
(
10.3
-
Materials for Setting Welding Conditions)
↓
Setting wire material, shield gas, and travel speed
(
6.6.1
-
Welding mode setting)
↓
Setting wire diameter
(
6.6.1
-
Welding mode setting)
↓
Setting crater treatment
(
6.6.4
-
Crater setting
-
)
↓
Setting pre-flow (Setting gas discharge time)
(
6.6.3
-
Setting welding parameter)
↓
Setting initial condition (Setting welding current/voltage)
(
6.6.3
-
Setting welding parameter)
↓
Setting welding condition (Setting welding current/voltage)
(
6.6.3
-
Setting welding parameter)
↓
Setting crater condition (Setting welding current/voltage)
(
6.6.3
-
Setting welding parameter, 6.6.4
-
Crater setting)
↓
Setting post-flow (Setting gas discharge time)
(
6.6.3
-
Setting welding parameter)
↓
Registering the welding conditions set above as necessary
(
6.5
-
Memory Function of Welding Conditions)
Summary of Contents for Welbee M350 II
Page 1: ...Welbee M350 II M500 II OWNER S MANUAL July 2021 Manual No P30355 1 DAIHEN Corporation...
Page 140: ...REFERENCE DRAWING REFERENCE MATERIALS CHAPTER 10 138...
Page 141: ...139 Chapter 10 Reference Materials REFERENCE DRAWING REFERENCE MATERIALS CHAPTER 10 WB M502...
Page 142: ...REFERENCE DRAWING REFERENCE MATERIALS CHAPTER 10 140...
