S
ETTING
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
74
&UDWHU21ZLWKLQLWLDOFRQGLWLRQ
Select "CRATER-FILL ON" by the CRATER-FILL menu and select "INITIAL CONDITION ON" by the INITIAL
CONDITION menu.
•
Carry out twice the ON/OFF operation of the torch switch and carry out the welding operation. The operation from
the first ON to OFF enables the welding by the initial current, and the second ON operation enables the welding by
the crater current.
•
Even if the torch switch is switched off during welding, the signal will be self-hold. (The torch switch should remain
depressed and held during the INITIAL and CRATER phrases.)
•
Welding method in the initial condition is the same with the main welding.
Anti-stick time
Slow-down speed
OFF
Crater-fil
䡈
OFF
Main welding
Torch switch
Gas flow
Output voltage
Wire feeding speed
Welding current
Initial current
Pre-flow
Post-flow
No-load voltage
Welding current
Crater-fill current
ON
OFF
ON
OFF
Initial condition
ON
ON
Summary of Contents for Welbee M350 II
Page 1: ...Welbee M350 II M500 II OWNER S MANUAL July 2021 Manual No P30355 1 DAIHEN Corporation...
Page 140: ...REFERENCE DRAWING REFERENCE MATERIALS CHAPTER 10 138...
Page 141: ...139 Chapter 10 Reference Materials REFERENCE DRAWING REFERENCE MATERIALS CHAPTER 10 WB M502...
Page 142: ...REFERENCE DRAWING REFERENCE MATERIALS CHAPTER 10 140...
