OTC Welbee M350 II, Owner'S Manual

Page: 61 / 148

59
Chapter 6 W
elding Condition
L
IST OF
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
F72
Setting arc-ON time
(Interval function)
0.20 to 9.99 1.00 (s) Sets the arc-ON time in the Interval welding function.
9
F73
Setting arc-OFF time
(Interval function)
0.20 to 9.99 1.00 (s) Sets the arc-OFF time in the Interval welding
9
F74 to
F76
No function OFF (fixed) OFF No functions are provided. -
F77
Welding source identification
numbers
1 to 999 1
Sets whether power source identification numbers of
Welding result control function.
-
F78
Prevention of unintended torch
switch operation
OFF/ON OFF
An error code is displayed when welding is not
performed for five seconds after the pre-flow.
-
F79
Switching of CAN
communication connection
device
0/1/2/3
0
Sets the connection device to be used for the CAN
communication.
0: Digital Remote Control Box
1: Digital panel (Attached to the wire feeder) and Intelli
torch
2: Push-Pull torch
3: Inline assist feeder
-
F80
Switching of CAN
communication speed
0/1/2/3
0
Sets the connection speed of the CAN connection.
0: 500 kbps
1: 1 Mbps
2: 125 kbps
3: 250 kbps
-
F81 TIG Mode switch setting OFF/ON OFF
During TIG MODE, operating the torch switch can control
the welding start and end.
-
F82 No function OFF (fixed) OFF No functions are provided. -
F83
Arc length adjustment right after
starting
-20 to 10 0
Adjusts the arc length right after starting the welding
operation.
-
F84,
F85
No function OFF (fixed) OFF No functions are provided. -
F86
Current display adjustment
(GAIN)
-20 to 20 0 (%)
These functions are for adjusting current value
displayed on the digital meter.
-
F87
Current display adjustment
(OFFSET)
-20 to 20 0 (A)
F88
Voltage display adjustment
(GAIN)
-20 to 20 0 (%)
These functions are for adjusting voltage value
displayed on the digital meter.
-
F89
Voltage display adjustment
(OFFSET)
-2.0 to 2.0 0.0 (V)
*1: WB-M352
*2: WB-M502
No. Function Name Setting range Initial value Explanation Memory