Orion OLW-4651, User Manual

Page: 4 / 42

※ Cautions for consisting System
Caution for the other control program besides MLCD Control
Program (MSCS)
- If you want to use automatic power on/off function that make MLCD turned on/off by
connecting main power, allow at least 20 seconds of Stand-by time before MLCD is
turned on, when you make control program.
- If RS-232C communication signal or other image signal is applied to 9 or more sets
simultaneously, communicational error may occur. (Power on & Broadcast)
Environmental condition for installation
- Since MLCD panel is very sensitive for physical impact, installation requires
considerable caution.
- Minimum clearance(20cm) must be secured for smooth ventilation. (See page
5, 16~17)Installation must avoid air tight or near air tight places. Improper
ventilation causes malfunction and shortens product lifetime by rapid internal
temperature rise. If MLCD has to installed at the improper ventilation, additional
ventilation openings or fans must be provided to keep the internal temperature
between 0 ~ 35˚C.
- For ground of MLCD and application devices, it should be connected as frame
ground.
- Considering MLCD Max power consumption, check the main electric specification.
Consideration for easier service
- When you design the exterior design for MLCD system, consider easier disassembly
for possible service occasion in the future.
- The sliding Universal Unit of ORION is recommended for easier service.
- If service people can step into the backside of MLCD system, it can greatly reduce
time and effort for service.
- In case of higher locations, consider the installation location and exterior design for
easier service.
- 4 - - 5 -
ORION
Hybrid Video System
W
ARNING
W
ARNING
- When you install MLCD, make sure there is at least 20cm clearance for
effective ventilation and do not seal off MLCD sets.
If MLCD sets are installed at the locations of bad ventilation, the inner
temperature can be raised rapidly and it can cause frequent malfunctions and
rapid reduction of the product life.
※ Ventilation space in front of MLCD must be furnished for heat dispersion.If
the front space of MLCD has to be sealed, there must be consideration for
the heat dispersion in the rear side of MLCD.
※ Clearance for Ventilation