Oriental motor EZ limo ESMC-A, Operating Manual

Page: 4 / 72

1 Introduction
－
4
－
1.4 Compliance with the EC directives
The controllers bear the CE mark indicating their compliance with the Low Voltage and EMC Directives,
based on combinations with the products specified below.
The controllers do not comply with the EC Directives if combined with other products.
•
Installation conditions
Controller, teaching pendant
Controller is to be used as a component within other equipment.
ESMC-K ESMC-A , ESMC-C EZT1
Overvoltage category Ⅰ Ⅱ −
Pollution degree 2 2 2
Protection against electric
shock
Class Ⅲ Class Ⅰ −
Protective range IP10 IP10 IP40
Motorized actuator
EZSM
†
K EZSM
†
A
,
EZSM
†
C SPFM
†
K SPVM
†
K SPRM
†
K
Overvoltage category Ⅰ Ⅱ Ⅰ
Pollution degree 2 2 2
Protection against electric
shock
Class Ⅲ Class Ⅰ Class Ⅲ
Protective range IP20 IP20 −
Noise level 71 db 71 db 71 db
•
Environmental condition
Operation environment Storage environment Shipping environment
Ambient
temperature 0 to +40 °C (+32 to +104 °F)
(non-freezing)
− 25 to +70 °C ( − 77 to +158 °F) (non-freezing)
Ambient
humidity
85% or less (non-condensing)
Altitude
Up to 1000 m (3300 ft.) above sea level
Up to 3000 m (10000 ft.)
above sea level
Surrounding
atmosphere • Area that is free from an explosive nature or toxic gas (such as sulfuric gas) or liquid
•
Area not exposed to direct sun
• Area free of excessive amount dust, iron particles or the like
• Area not subject to splashing water (storms, water droplets), oil (oil droplets) or other
liquids
•
Area free of excessive salt
• Area not subject to continuous vibration or excessive shocks
• Area free of excessive electromagnetic noise (from welders, power machinery, etc.)
• Area free of radioactive materials, magnetic fields or vacuum
Low Voltage Directive
ESMC-K ESMC-A
,
ESMC-C EZT1
Applicable
standards
The ESMC-K is not subject to the Low
Voltage Directive, because its input
voltage is 24 VDC. EN 50178
EN 60950
EN 60204-1
EZSM
†
K EZSM
†
A
,
EZSM
†
C
Applicable
standards
The
EZSM
†
K
is not subject to the Low
Voltage Directive, because its input
voltage is 24 VDC.
EN 60950, EN 60034-1, EN 60034-5
IEC 60664-1