9
Basic Setting
(Factory Setting)
Universal Controller
Driver
Actuator
Pulse Input Type
■
System Configuration
Type that executes operation by inputting pulses into the driver.
Drive the actuator using the positioning unit (pulse generator) you are familiar with.
■
Driver Function
Function
Overview
Selection of Pulse Input Mode
You can select the 1-pulse input or 2-pulse input (negative logic) mode with the pulse input mode select
switch (SW2-1).
Resolution Setting
You can set the resolution with the resolution setting switch (SW1).
AWO (All windings off) Input
This is an input signal for shutting down the current flowing to the actuator.
CS (Step angle switching) Input
You can select the resolution.
ACDOFF (Automatic current cutback release)
Input
This input signal is used to disable the current cutback function.
TIM (Timing) Output
This is output each time the rotor rotates 7.2 degrees.
