Orban OPTIMOD-FM 8700, Operating Manual

Page: 58 / 390

1-28
INTRODUCTION ORBAN MODEL 8700i
clipper mode and some without, switching between these presets is likely
to cause clicks unless you do it during silence. However, these clicks will
never cause modulation to exceed 100%.
One of the essential differences between the H
ARD
and LLH
ARD
bass clip-
per modes is that switching between
H
ARD
and
M
ED
does not change de-
lay and is therefore less likely to cause audible clicks.

Ultra-low latency processing uses a separate, parallel processing structure and is
invoked by recalling any “UL” preset. This structure operates simultaneously
with other code, so, unlike the similar structure in Orban’s Optimod 8300, it does
not require a code re-load and does not cause a gap in programming.
The only way to create an ultra-low latency user preset is to start with a
“UL” factory preset and then edit that preset. “UL” user presets cannot
be directly converted to low latency or optimum latency presets because
the preset customization controls are different—UL presets have fewer
available controls because of the difference in processing structure.
UL presets are the closest emulations of Optimod 8200 processing availa-
ble in the 8700i. These presets differ from Optimod 8200 processing in
two main ways: (1) the 8700i UL presets still use the 8700i’s stereo en-
hancement, equalization section, advanced-technology AGC, composite
limiter, and multiplex power controller, and (2) the 8700i UL presets use
anti-aliased clippers operating at 256 kHz sample rate.
Some talent moving from an analog processing chain will require a learning period
to become accustomed to the voice coloration caused by “bone-conduction” comb
filtering. This is caused by the delayed headphone sound’s mixing with the live voice
sound and introducing notches in the spectrum that the talent hears when he or she
talks. All digital processors induce this coloration to a greater or lesser extent. For-
tunately, it does not cause confusion or hesitation in the talent’s performance unless
the delay is above the psychoacoustic “echo fusion” (Haas) threshold of approxi-
mately 20 - 25 ms and the talent starts to hear slap echo in addition to frequency re-
sponse colorations.
Low-Delay Monitoring
The 8700i’s analog outputs can be switched to provide a low-delay monitoring feed
with a delay of 5-10 ms (see step 17 on page 2-38). This uses a separate instance of
the Ultra-Low-Latency structure to allow the monitor to provide a “FM-processed”
sound. You can adjust the amount of “FM peak limiter sound” via the
M
ONITOR
D
RIVE
control.
If the talent relies principally on headphones to determine whether the station is on
the air, simple loss-of-carrier and loss-of-audio alarms should be added to the sys-
tem. The 8700i can be interfaced to such alarms through any of its eight its GPI re-
mote control inputs, cutting off the low-delay audio to the talent’s phones when an
audio or carrier failure occurs.
The front panel headphone jack provides output matching the Analog Output, ex-
cept that it is always de-emphasized (even if the Analog Output is set with
preemphasis).