Orban OPTIMOD-FM 8700, Operating Manual

Page: 158 / 390

2-96
INSTALLATION ORBAN MODEL 8700i
COMMAND PARAMETER INFORMATION EXAMPLE
TIMEOUT=
RDS terminal
connection
timeout Timeout (in minutes) between last
transmitted command and when
the Optimod disconnects automat-
ically. Use it to allow the Optimod
to reconnect automatically if the
terminal connection is lost tempo-
rarily.
This command only affects
the current connection; you must
reissue it each time you connect.
TIMEOUT=15

(current connection
stays up for 15
minutes)
TIMEOUT=0

(no auto-disconnect
occurs)
VER

RDS Welcome
Header
{ 0=No, 1=Yes } Sets whether the
RSD welcome header is sent to
the Network client upon connec-
tion.. VER 0

INIT

Use System RDS
parameters Use RDS parameters from Sys-
tem. INIT

SAVE

Save RDS pa-
rameters saves the current RDS parame-
ters to the currently active RDS
control set (either the System Set-
tings or the User Preset group)
NOTE: Any changes will not ap-
pear in the PC application if it is
open. You must reconnect to see
the saved values. SAVE

QUERIES
[command]

Any command and ‘?’ returns the status of the encoder
memory for that specific command..
PS?

ST

Returns all settings in encoder memory. ST

HELP

Reports a list of available commands HELP

TI

Returns the current time, as read from the Optimod’s real-
time clock.
TIME=20:15:36
DATE=Jan.
1,
2015
ESPONSES
(Return Echo)
The command received was properly formatted and was re-
ceived and executed by the encoder. TATIME=30
Invalid Data
Entered Incoming data is not properly formatted and hence was not
accepted and executed by the encoder. Invalid Data En-
tered
(none) Data that has been sent either has not reached the encoder
or the encoder has no response for that command. (none)
Table 2-2: Preset/Terminal RDS controls and defaults