Orban OPTIMOD-FM 8700, Operating Manual

Page: 124 / 390

2-62
INSTALLATION ORBAN MODEL 8700i

SSB:. switches the 8700i’s stereo encoder on using compatible single side-
band/vestigial sideband modulation of the stereo subchannel. See SSB Stereo
Encoder Operation on page 3-12.

Mono From Left, Mono From Right, or Mono From Sum: switches the 8700i’s
stereo encoder off, using the Left, Right, or Sum (L+R) respectively, as the
program source.

MOD Reduction 1, or MOD Reduction 2: reduces the program modulation by
the percentage programmed in the Input/output screen. When voltage is
removed, these functions are deactivated.

Reset Clock To Hour

Reset to Midnight

Monitor Mute is a non-latching function that mutes the analog output if it has
been programmed to emit the monitor signal (in the
I
NPUT
/O
UTPUT
: O
UTPUT
1
screen).

Analog Out Delay In: Activates the diversity delay for the analog output if it is
configured to emit the output of the analog FM processing chain (see page
3-77).

Digital Out 1 Delay In: Activates the diversity delay for Digital Output #1 (Ana-
log, Digital #1, Digital #2, Composite) if it is configured to emit the output of
the analog FM processing chain (see page 3-77). There is also a
D
IGITAL
O
UT
2
D
ELAY
I
N
choice available.

Analog Out Delay Out: Bypasses the diversity delay for a specified output (An-
alog, Digital #1, Digital #2, Composite) emitting the output of the analog FM
processing chain (see page 3-77).
D
IGITAL
O
UT
1 D
ELAY
O
UT
and
D
IGITAL
O
UT
2
D
ELAY
O
UT
are also available
.

FM Polarity Positive: Makes positive the output polarity of the 8700i’s FM ana-
log channel processing. In HD Radio installations, this command is useful
when switching the 8700i between transmitters if the transmitters’ exciters
produce opposite FM modulation polarities when driven by identical digital
audio input signals. This setting affects any output emitting the analog FM
processed signal, including the composite output.

FM Polarity Negative: (see above)

No Function: remote input is disabled.
3. End remote control interface programming.
When you are finished programming the remote control interface, press the Es-
cape
button once to return to the System Setup screen.