Orban OPTIMOD-FM 8700, Operating Manual

Page: 123 / 390

OPTIMOD-FM DIGITAL INSTALLATION
2-61
The file “8700i_P1_Gregg.cmd” contains:
nc.exe -v -n -w 1 123.45.67.89 23 < 8700i_P1_Gregg.txt
The file “8700i_P1_Gregg.txt” contains:
RP GREGG [PASSWORD]
disconnect
The file “8700i_P2_GreggOpen.cmd” contains:
nc.exe -v -n -w 1 123.45.67.89 23 < 8700i_P2_GreggOpen.txt
The file “8700i_P2_GreggOpen.txt” contains:
RP GREGG OPEN [PASSWORD]
disconnect
Remote Control Interface Programming
[Skip this section if you do not wish to program the opto-isolated GPI remote control
interface at this time.]
1. Navigate to the System Setup > Network Remote screen.
2. Program one or more remote control interfaces.
To program a given remote input, use
L
OCATE
to highlight the input. As you turn
the control knob, the functions listed below will appear in the highlighted field.
A momentary pulse of voltage will switch most functions, except as noted.

Preset Name: switches that preset on the air. Any factory or user preset may
be recalled via the control interface.

Input: Analog: selects the analog inputs.

Input: Digital: selects the digital input. No J.17 de-emphasis is applied to the
digital input.

Input: J.17: selects the digital input and applies J.17 de-emphasis to
the digital input.

Bypass: switches the Bypass Test Mode on the air.

Tone: switches a Tone Test on the air.

Exit Test: If a test mode (Tone or Bypass) is switched on the air,
EXIT TEST
re-
verts to the normal operating mode using the previous processing preset.

Stereo: switches the 8700i’s stereo encoder on using normal double sideband
modulation of the stereo subchannel.