One World Touch OP 1200, Service Manual

Page: 21 / 135

Service Manual version 1008
OP 1200/1500/1700 (PC920 Intel 945G)
2-13
2.4. Powering up the System
Upon receipt of the OP SERIES, the system should have been properly set up and configured by
your dealer.
To power up the system, follow the procedures below.
1. Find the power cord from the accessory box. Connect the
3-pin female end of the power cord to the AC inlet located
at the right rear lower side of the panel PC. Plug the 3-pin
male end to an AC power socket.
2. If there are any other peripheral devices connected to the
system, make sure all the device cables are properly
retained and connected to the panel I/O ports.
3. Power on the external peripheral devices first.
4. When facing the system, from your point of view, the power switch is at the right rear lower
side of the panel PC. Press the power switch.