The detail description of a screen
1.
UPS-UPS Shutdown
The enable/disable of an uninterruptible power supply (UPS)
remote shutdown is set up.
2.
Work as master/slave UPS
It specifies that which is used for this UPS between the
master(UPS) or the slave(UPS). A master is only one set although
it is possible to cooperate as one group and to operate two or
more sets (UPS) of uninterruptible power supplies.
3.
Event Occurs on Master/Slave UPS
It set the operation when a shutdown event occurs in
uninterruptible power supply (UPS) of only one of either.
4.
Notify Master UPS / Ignore information from Slave UPS
By setup, only a master or a slave uninterruptible power supply (UPS)
goes into stop operation.
The operation in the case of a stop follows a shutdown setting.
5.
Notify ALL
All the uninterruptible power supplies (UPS) that have a
cooperation relation (a master, slave relations) go into stop
operation.
In any case, stop operation follows a shutdown setting.
6.
UPS Master(IP Address)
The IP address of a master uninterruptible power supply (UPS) is
set up. If set up correctly, it will register with the client table of a
master uninterruptible power supply (UPS).
Please refer to a [2.6 setup of a remote shutdown] about details of
operation.
25